- About the Honeywell Orbit 7120 Hands-Free Barcode Scanner
- Installing
- Enabling UPC-E Support
- Disabling UPC-E Support
- Reset to Default Configuration
(Image courtesy of Honeywell®)
About the Honeywell Orbit 7120 Hands-Free Barcode Scanner
The Honeywell Orbit hands-free barcode scanner scans linear barcodes of products. The scanner can also be used to scan identification badges with linear barcodes.
Installing
Plug the USB cable into a USB port on the touchscreen or USB hub.
Warning! Do not plug the USB cable into the printer!
Enabling UPC-E Support
The default configuration of the Honeywell® Orbit 7120 barcode scanner does not support UPC-E (the leading zero and the check digit (last digit) are not transmitted when a UPC-E is scanned).
To enable UPC-E support for the scanner, you will be required to scan the two codes below. To do so, print this browser page, and then scan the codes from the printed page.
Transmit Leading Zero
Transmit Check Digit
Disabling UPC-E Support
To disable UPC-E support for the scanner (in which the leading zero and the check digit (last digit) are not transmitted when a UPC-E is scanned), you will be required to scan the two codes below. To do so, print this browser page, and then scan the codes from the printed page.
Do Not Transmit Leading Zero
Do Not Transmit Check Digit
Reset to Default Configuration
To reset the scanner to its default configuration, you will be required to scan the code below. To do so, print this browser page, and then scan the code from the printed page.